![]() ![]() ![]() ![]() I tried Wireshark and it didn't see the Linksys interface at all. Operation Mode: "Extensible Station (ExtSTA)"Įnter the choice (0, 1.) of the wireless card you want to operate on:Įnter the operation mode (0, 1 or 2) you want to switch to for the chosen wireless card: WlanHelper.exe -iĭescription: Marvell AVASTAR Wireless-AC Network Controller Or maybe I need to play with other drivers.īTW, the "interactive mode" in WlanHelper is really convenient! It should get more attention in the documentation: I've given up on anything being able to get the Marvell into monitor mode, but I bought the Linksys because all the monitor-focused web sites said it was great for monitor mode in Windows 10. It can obviously send the managed command to either adapter. Like you, I'm sure I installed Npcap with monitor enabled. I can talk to the Marvell, but most commands to the Linksys fail:Ĭ:\Windows\System32\Npcap>WlanHelper.exe Wi-Fi modeĬ:\Windows\System32\Npcap>WlanHelper.exe "Wi-Fi 2" modeĬ:\Windows\System32\Npcap>WlanHelper.exe "Wi-Fi" channelĬ:\Windows\System32\Npcap>WlanHelper.exe "Wi-Fi 2" channelĬ:\Windows\System32\Npcap>WlanHelper.exe "Wi-Fi" mode monitorĮrror: SetWlanOperationMode::SetInterface error, error code = 50 (The request is not supported)Ĭ:\Windows\System32\Npcap>WlanHelper.exe "Wi-Fi 2" mode monitorĬ:\Windows\System32\Npcap>WlanHelper.exe "Wi-Fi" mode managedĬ:\Windows\System32\Npcap>WlanHelper.exe "Wi-Fi 2" mode managed what could I do ? Can I send you some log files of my errors ? Where are they located ? Which I want because my 802.11n access point is set to channel 3, but I getĮrror: makeOIDRequest::My_PacketOpenAdapter error (to use this function, you need to check the "Support raw 802.11 traffic" option when installing Npcap)Įven though I triple checked I did indeed check the "Support raw 802.11 traffic" option when installing Npcap. WlanHelper "Wireless Network Connection 2" channel 3 Returns "success" and puts the CISCO WUSB600n in monitor mode while my native wifi interface accesses the internet. WlanHelper "Wireless Network Connection 2" mode monitor ![]() I uninstalled Wincap and successfully installed, and the command My computer, a lenovo naturally has wifi, so I'd like to use that to connect to the internet as I usually do and use the CISCO WUSB600n in monitor mode, for testing purposes. I am running Windows 7 professional, I use a CISCO WUSB600n USB Wireless device my system recognizes and which functions properly when I use it to access the internet. I apologize for my noobie question but after looking hard for threads with the solution to my problem, I'm still stuck so. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |